GBC AdvancedPunch Pro - GP 6.15 Drive Roller and Steering Drive Roller Inspection and Cleaning

GBC AdvancedPunch Pro 09/11/2018 General Procedures and Information
6-65
GP 6.15 Drive Roller and Steering Drive Roller Inspection and
Cleaning
Do this procedure to inspect and clean the Drive Rollers and Steering
Drive Rollers.
Maintenance Schedule
Inspect and clean every 1000K cycles.
Procedure
Some drive rollers are not easily accessible. Those that are [1], should be
inspected and cleaned when the idler rollers are removed.
Where practical, make sure the rollers are clean. Clean with a soft cloth
and alcohol.
See also, GP 6.14.1 Idler Roller Cleaning on page 6-63.
It is recommended to clean the Drive Rollers with the Punch Module
removed, because with the Punch Module removed it is easy to access all
Drive Rollers.
1. Do REP 3.1.1 Punch Module Removal.
2. Clean all Drive Rollers N1 – N16 with a clean cloth and alcohol.
3. The Drive Roller should be free of toner deposits, wear marks, scuff
marks, dents, etc.
4. Use the above procedure to clean the Steering Drive Rollers
5. Do REP 3.1.2 Punch Module Installation.
Steering Drive Rollers