GBC AdvancedPunch Pro - Error Codes; Error E451 die Encryption Error; Error E452 Incompatible die

GBC AdvancedPunch Pro 11/07/2018 RAPS
2-11
ERROR CODES
The User Interface displays two error messages when the firmware
detects that an item is bad or not functioning. There are only 2 error
codes.
Error Code Description
E451 Die encryption error
E452 Incompatible die
ERROR E451
DIE ENCRYPTION ERROR
The top row of text displays the fault error message number the bottom
row displays the description.
NOTE: If there is an ERROR message when downloading firmware
(either DFA_MAIN.BIN or DFA_COMM.BIN file), the firmware should be
downloaded again.
ERROR E451 DIE ENCRYPTION ERROR
This means that the die is not a GBC certified die.
1. Open the Front Door (PL 2.1).
2. Remove the Die Set (see AdvancedPunch Pro User Manual).
3. Check that the Die Set is the correct Die Set for the Punch.
The Die Set is the correct die Set for the Punch.
Y N
Replace the Die Set (PL 6).
Escalate to second level.
ERROR E452 INCOMPATIBLE DIE
This means the die is not a certified FX/Xerox die.
1. Open the Front Door.
2. Remove the Die Set(see AdvancedPunch Pro User Manual).
3. Check that the Die Set is the correct Die Set for the Punch
(see AdvancedPunch Pro User Manual).
The Die Set is the correct die Set for the Punch.
Y N
Replace the Die Set (PL 6).
Escalate to second level.