GBC AdvancedPunch Pro - GP 6.19 Punch Paper Path Inspection and Cleaning

GBC AdvancedPunch Pro 09/11/2018 General Procedures and Information
6-71
GP 6.19 Punch Paper Path Inspection and Cleaning
Do the following to inspect and clean the Punch Paper Path every 1000K
cycles.
1. Inspect the entire paper path through the punch. Look for wear,
damage, and obstructions.
2. Inspect the rollers for wear patterns or groves.
3. Open the Entrance Idler Panel, Acceleration Roller Idler, and Exit
Idler Panel and make sure there are no obstructions.
4. Confirm that the Entrance Idler Panel Latch, Acceleration Roller Idler
Latch, and Exit Idler Panel Latch hold the panels tightly in place.
If the latch is bent or damaged, replace the Entrance Idler Panel
(REP 2.2), Acceleration Roller Idler Assembly (REP 2.3), or the Exit
Idler Panel (REP 2.6).
5. Clean as needed.