GBC AdvancedPunch Pro - Configure the Punch; Firmware Installation

GBC AdvancedPunch Pro 08/20/2015 Installation Instructions- DFA
8-15
8.16. Configure the Punch
1. Do GP 6.1.6 LANGUAGE MODE Procedure to set the desired
language.
2. Do GP 6.1.7 UNITS MODE Procedure to set the desired units (mm or
inches).
3. Do GP 6.2.2 SPEED (DFA) Procedure to set the desired speed.
4. Do GP 6.1.8 PAPER SIZE Procedure to set the desired paper size.
8.17. Firmware Installation
Do the following to install the latest version of the firmware.
1. Check with second level support to determine the firmware version
(e.g. 1.02).
2. Do GP 6.1.12 to check the firmware version installed in the
AdvancedPunch Pro.
FIRMWARE
1.00
1.00
3. If the firmware version is out of date, perform GP 6.2.16 FIRMWARE
UPGRADE Procedure to update the firmware.
LOG
*
FIRMWARE UPGRADE
When you install a GBC you also install the 2.2.xx FW on the PSK
and set the PSK NVM#9099 from 1 to 3.
If you ever install different printer software and may download an
older version of PSK FW (ex. 2.02.74) then the shutter on the PSK
will make a grinding noise when going to unload and raise a FTM-12-
2940 “Stacker Door Motor M83 Motion timeout error” fault. To prevent
this grinding noise, reload the 2.2.xx FW or if removing the GBC, set
the NVM#9099 back to a 1.