GBC AdvancedPunch Pro - REP 2.17 Accel Idler Latch Shaft, Rear Latch and Front Latch Assembly Replacement

Repairs/Adjustments 08/20/2015 GBC AdvancedPunch Pro
4-50
REP 2.17 Accel Idler Latch Shaft, Rear Latch and Front Latch
Assembly Replacement
PARTS LIST ON PL 3.5
Use this procedure to remove and install one or more of the following:
 Accel Idler Latch Shaft
 Accel Idler Panel Rear Latch Assembly
 Accel Idler Panel Front Latch Assembly
Removal Procedure
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do REP 1.6 to remove the Rear Cover.
4. Do REP 3.1.1 to remove the Punch Module.
5. Unhook the Extension Springs from the Accel Idler Panel Front and
Rear Latches.
6. Remove the M3 screws (2) from the Accel Idler Panel Front and Rear
Latches.
7. Remove the E-clip from the Accel Idler Shaft on the rear side.