Service Manual 11/07/2018 GBC AdvancedPunch Pro
xviii
Acronyms
Acronyms are used in the parts list to provide information in a limited
amount of space. The following table lists the abbreviations used in this
manual:
Acronym
Meaning
CBL
Cable
DRV Motor Driver (Stepper Board)
F Fuse
FAN
Fan
GND Ground
M Motor
P Plug
J Connector
PSU Power Supply
S Sensor
SW Switch
SOL Solenoid
UI User Interface
The list above uses standard Xerox nomenclature.
Reference Symbology
Notes, adjustments, and parts lists, support the checklists and the RAP
information. The symbols that refer to this supportive data are shown
below.
Adjustment
ADJ 3.2
The mechanical adjustment symbol
indicates the component is adjustable
and the number identifies the
adjustment procedure location in the
Repair and Adjustments section of
this manual.
Note
This symbol is used to refer to notes
usually found on the same page.
Parts List
[PL 1.2] refers to the parts list located in Section 5 of this Service
Documentation. The number after the PL designation indicates the
number that is assigned to that parts list.
To Next Page
Loading...
