GBC AdvancedPunch Pro - Tools; Other Recommended Tools and Supplies; Standard Tools (Metric); Lubrication

General Procedures and Information 09/11/2018 GBC AdvancedPunch Pro
6-86
Tools
Tools recommended for service of the GBC Advanced Punch Pro:
Standard Tools (metric)
 7mm Nut Driver
 5.5mm Nut Driver
 7mm Open End Wrench
 5.5mm Open End Wrench
 Needle Nose Pliers
 Phillips Screwdriver
 Flathead Screwdriver
 Wire Cutters
 Metric Allen Key Set (1.5mm, 2mm, 2.5mm, 3mm, 4mm, 5mm)
Other Recommended Tools and Supplies
 0.25mm, 1mm, and 3mm Shim Gauges
 0 to 2 kgf Force gage
 Loctite
 10mm Open End wrench
 6mm Allen Key
 150mm Metric ruler
Lubrication
For General lubrication please see the following sections
 GP 6.7.3, Die Set Lubrication
 GP 6.20, Punch Drive Cam Lubrication