GBC AdvancedPunch Pro - GP 6.1.10 die CYCLES Procedure

General Procedures and Information 09/11/2018 GBC AdvancedPunch Pro
6-22
GP 6.1.10 DIE CYCLES Procedure
The Die Cycles feature lists the total number of sheets punched with the
Die Set currently installed in the AdvancedPunch Pro.
1. From the top level screen,
READY
SINGLE PUNCH
2. Press either the up arrow button or the down arrow button to display
the SETTINGS/ INFORMATION screen.
SETTINGS
INFORMATION
3. Press the down arrow button to move the return symbol down until it
is next to the word INFORMATION
SETTINGS
INFORMATION
4. Press the ENTER button to display the DIE TYPE – DIE CYCLES
screen.
DIE TYPE
DIE CYCLES
5. Press the down arrow button so the return symbol is next to the words
DIE CYCLES.
DIE TYPE
DIE CYCLES
6. Press the ENTER button when the return symbol is next to the words
Die Cycles. to display the DIE CYCLES screen.
DIE CYCLES
17,129
7. If any of the Die Set life cycles have exceeded 750,000 sheets
(cycles) go to Section 3 and check the Hole Quality.
 If the Hole Quality is acceptable monitor the Hole Quality
frequently to ensure that the Hole Quality is okay.
 If the Hole Quality is not acceptable replace the Die Set.
8. Press the ENTER button to display the DIE TYPE – DIE CYCLES
screen.
DIE TYPE
DIE CYCLES
9. Press the up arrow button three times to display the EXIT option.
EXIT
PREVIOUS MENU
10. Press the ENTER button to return to the top level screen
READY
SINGLE PUNCH