GBC AdvancedPunch Pro 09/11/2018 General Procedures and Information
6-59
GP 6.8 External Cleaning
Do the following to clean the exterior of the AdvancedPunch Pro.
1. Clean the exterior covers with a soft cloth moistened with mild
detergent and warm water.
Do not use chemical cleaners or solvents as these may have a harmful
effect. Use detergent sparingly to avoid contact with electrical
components.
Warning: Make sure you disconnect the AdvancedPunch Pro from its
power source before cleaning. Failure to observe this warning could result
in death or serious Injury. See Section 0, page vii for other languages.
GP 6.9 Internal Cleaning
Do the following to clean the interior of the AdvancedPunch Pro.
1. Occasionally remove the covers and remove paper dust and chips.
Paper dust can accumulate throughout the punch including around
the motor and other electrical components.
Use a vacuum cleaner if possible. A small paintbrush can also be
used but extreme care should be used around electrical components.
2. Clean non-electrical components with alcohol, an approved cleaner,
or a soft cloth moistened with mild detergent and warm water.
3. Clean the Rollers with alcohol.
Warning: Make sure you disconnect the AdvancedPunch Pro from its
power source before cleaning. Failure to observe this warning could result
in death or serious Injury. See Section 0, page vii for other languages.
To Next Page
Loading...
