GBC AdvancedPunch Pro - REP 3.11 Steering Idler Roller Assembly Replacement

GBC AdvancedPunch Pro 08/20/2015 Repairs/Adjustments
4-105
REP 3.11 Steering Idler Roller Assembly Replacement
PARTS LIST ON PL 5.4
Use this procedure to remove and install a Steering Idler Roller Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to entire printing system.
2. Disconnect the Power Cord.
3. Do REP 1.6 to remove the Rear Cover.
4. Do REP 3.1 to remove the Punch Module.
5. Disconnect the Skew Sensor Board Connector.
6. Release the Cable Clamp and move the Cable out of the way.
7. Remove the M4 Nuts (2).
8. Remove the Roller Cover.
9. Gently move the Springs (2) off the ends of the Roller.
Steering Idler Roller Assembly
Roller Cover