GBC AdvancedPunch Pro 09/11/2018 General Procedures and Information
6-55
GP 6.5 Operational Inspection
Do the following on every service call to make sure the system is
operating properly.
1. Make sure the punch operates smoothly and produces the desired
holes in the customer’s paper.
2. Refer to section 3.14 Punch Specifications.
GP 6.6 Internal Inspection
Do the following whenever the cover has been removed for corrective
maintenance,
1. Visually inspect for defects and problems such as damaged
components, loose screws or nuts, abraded wire insulation, loose
terminals, etc.
2. Correct any problems before returning the machine to service.
To Next Page
