Keysight x-series - Page 54

Table Of Contents
SYSTem:PERSona:MANufacturer 1853
SYSTem:PERSona:MANufacturer:DEFault 1853
SYSTem:PERSona:MODel 1853
SYSTem:PERSona:MODel:DEFault 1854
4.2.5 LXI 1854
4.2.5.1 LAN Reset 1854
4.2.5.2 Device Identification (Remote Command Only) 1854
4.2.6 Restore I/O Config Defaults 1855
4.2.7 Query USB Connection (Remote Query Only) 1855
4.2.8 USB Connection Status (Remote Query Only) 1856
4.2.9 USB Packet Count (Remote Query Only) 1856
4.2.10 Lock Remote I/O Session (Remote Command only) 1857
4.2.10.1 Lock Remote I/O Request (Remote Query only) 1858
4.2.10.2 Unlock Remote I/O Session (Remote Command only) 1859
4.2.10.3 Remote I/O Session Lock Name (Remote Query only) 1860
4.2.10.4 Remote I/O Session Lock Owner (Remote Query only) 1860
4.2.11 Multiple Network Interface Card Configuration (Remote
Commands Only) 1861
4.2.11.1 Multiple Network Adapters Enabled (Remote Query Only) 1861
4.2.11.2 Config IPV4 Address (Remote Command Only) 1862
4.2.11.3 Config IPV6 Address (Remote Command Only) 1862
4.2.11.4 List All Physical Network Adapter IP Addresses (Remote Query
Only) 1862
4.3 Preload / Unload Modes 1864
4.3.1 Power-On Mode 1864
4.3.2 Table of Modes 1865
4.3.3 Preload: Select All, Preload: Deselect All 1865
4.3.4 Move Up, Move Down 1865
4.3.5 Unload 1865
4.3.6 Loaded Modes (Remote Query Only) 1866
4.3.7 User Interface 1866
4.3.7.1 Menu Panel Position 1866
4.3.7.2 Menu Panel Tabs 1867
4.3.7.3 Annotations Local Settings/All Off 1867
54 Vector Modulation Analyzer Mode User's &Programmer's Reference