Keysight x-series - Page 64

Table Of Contents
Segment 2 Frequency 2116
IP Address 2117
SCPI Socket Port 2117
Add Secondary Module 2117
Delete Secondary Module 2117
Sync Runtime Settings (Remote Command Only) 2118
6.1.13.4 Sync Start 2118
6.1.13.5 Sync Stop 2118
6.1.13.6 Sync Connected (Remote Query Only) 2119
6.1.14 Source Preset 2119
6.2 Input 2120
6.2.1 Select Input 2120
6.2.2 RF Input Port 2129
6.2.3 SA Frequency Extender Firmware Update (Front Panel Only) 2139
6.2.4 SA Frequency Extender Cable Correction 2140
6.2.5 Half Duplex Input Port 2140
6.2.6 Port Information (Remote Command Only) 2141
6.2.7 RF Preselector 2141
6.2.8 Notch Filter 2143
6.2.9 RF Calibrator 2143
6.2.10 RF Coupling 2144
6.2.11 Input Z Correction 2146
6.2.12 All Screens Use Same Input 2147
6.2.13 External Mixer Setup 2147
6.2.13.1 Mixer Presets 2151
6.2.13.2 Mixer Bias 2156
6.2.13.3 Table Type 2157
6.2.13.4 Select VDI CCD Correction 2158
6.2.13.5 Delete All VDI CCD Corrections 2159
6.2.13.6 Harmonic 2159
6.2.13.7 LO Doubler 2160
6.2.13.8 Refresh USB Mixer Connection 2160
6.2.14 Mixer Path 2161
6.2.15 User IF Freq 2162
6.2.16 Signal ID On/Off 2162
64 Vector Modulation Analyzer Mode User's &Programmer's Reference