Keysight x-series - Page 79

Table Of Contents
9.2 IEEE 488.2 Common Commands 2542
9.2.1 *CAL? - Calibration Query 2542
9.2.2 *CLS - Clear Status 2543
9.2.3 *ESE - Standard Event Status Enable 2543
9.2.4 *ESR? - Standard Event Status Register Query 2544
9.2.5 *IDN? - Identification Query 2544
9.2.6 *OPC? - Operation Complete 2545
9.2.7 *OPT? - Query Instrument Options 2546
9.2.8 *RCL - Recall Instrument State 2546
9.2.9 *RST - Reset 2546
9.2.10 *SAV - Save Instrument State 2547
9.2.11 *SRE - Service Request Enable 2547
9.2.12 *STB? - Status Byte Query 2548
9.2.13 *TRG - Trigger 2548
9.2.14 *TST? - Self Test Query 2548
9.2.15 *WAI - Wait-to-Continue 2549
9.3 SCPI Operation and Results Query 2550
9.3.1 Mode Control 2550
9.3.2 Measurement Control 2550
9.3.2.1 CONFigure 2551
9.3.2.2 INITiate 2552
9.3.2.3 FETCh 2552
9.3.2.4 READ 2553
9.3.2.5 MEASure 2554
9.3.3 Trace Formatting Commands 2555
9.3.3.1 Clear Trace (Remote Command Only) 2555
9.3.3.2 Send/Query Trace Data (Remote Command Only) 2556
9.3.3.3 Format Data: Numeric Data (Remote Command Only) 2558
9.3.3.4 Format Data: Byte Order (Remote Command Only) 2559
9.3.3.5 Calculate/Compress Trace Data Query (Remote Command
Only) 2559
9.3.3.6 Calculate Peaks of Trace Data (Remote Command Only) 2565
9.3.3.7 Smooth Trace Data (Remote Command Only) 2567
Vector Modulation Analyzer Mode User's &Programmer's Reference 79