NEC Electra Elite IPK - DID Digit Length Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 27
___________________________________________________________________________________
___________________________________________________________________________________
1-1-20 DID Digit Length Selection
General Description
Use this Memory Block to define the number of Direct Inward Dialing (DID) digits in
Memory Block 1-1-22 (DID Digit Conversion Table).
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BK to access the Memory Block.
3 Enter the data using the dial pad.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
H to clear all data
Default Values
3 (Setting Data 2, 3, or 4)
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-21
DID Digit Conversion Assignment
1-1-22
DID Digit Conversion Table
1-1-23
DID Forward Station Number for Busy Station or Undefined Digit
5-00
Digit Add/Del For Tie Line Networking Assignment
System Mode
1
Submode
1
Data No.
20
PC Programming
¦ +ALN
2 0 : D I D D G T 3
T I M E D I S P L A Y
Setting
DataTitle
Data
No.
Title