NEC Electra Elite IPK - 1-16-15 VLAN Tag Insertion Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 409
___________________________________________________________________________________
___________________________________________________________________________________
1-16-15 VLAN Tag Insertion Selection
General Description
Use this Memory Block to specify whether or not the port should insert VLAN tags in
frames transmitted on this port. When this Memory Block is set to NO, tags are
deleted from frames of the same VLAN Group transmitted on this port.
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJAE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the option.
4 Press
G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU and VLAN Group.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
15
PC Programming
¦ +AB
1 5 : 1 T A G 0 1 = 1 N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
VLAN Gp
01~16
HUB
1~3
Port
1~8