Electra Elite IPK Document Revision 4
Programming Manual 2 - 511
___________________________________________________________________________________
___________________________________________________________________________________
4-09 Telephone to Tenant Assignment
General Description
Use this Memory Block to specify Tenant Assignment per station.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
KI
to access the Memory Block.
3 Use dial pad to change telephone to Tenant Assignment for Tel Port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
Default Values
All Telephones Tenant 00
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-01
Trunk To Tenant Assignment
2-05
Line Key Selection
2-06
Line Key Selection for Tenant Mode
2-07
System Speed Dial Display Assignment
2-08
ECR Relay to Tenant Assignment
Telephone Mode
4
Submode
—
Data No.
09
PC Programming
¦
+BTT
0 1 / 0 9 : T E N A N T = 0 0
T I M E D I S P L A Y
Data
No.
Tel
Port
No.
(01
~
COA
Title
Setting
Data
(00
~
47)
To Next Page
Loading...
