NEC Electra Elite IPK - Doorphone Display Time Selection

2 - 192 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-7-01 Doorphone Display Time Selection
General Description
Use this Memory Block to specify the time, in seconds, a doorphone call signals a
station before it times out.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (R2500 or lower)
Settings
Refer to next page for R3000 or higher Programming Procedures.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
10s 30s 60s 90s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK7 +
KA to access the Memory Block.
3 Press the CO/PBX line key corresponding to the time assignment.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
7
Data No.
01
PC Programming
¦ +BTP
0 1 : D P H T I M E R 1 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.