NEC Electra Elite IPK - Telephone Ringing Variation Selection

2 - 600 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-91 Telephone Ringing Variation
Selection
General Description
Use this Memory Block to assign a Low, Medium, or High ringing tone frequency when
Telephone is specified in Memory Block 1-1-28 (Distinctive Ringing by Telephone or
CO Selection).
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
MLH
Programming Procedures
1 Go off-line.
2 Press LK4 +
IA to access the Memory Block.
3 Press the line Key to select ringing frequency for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28
Distinctive Ringing by Telephone or CO Selection
3-07
CO/PBX Ringing Variation Selection
Telephone Mode
4
Submode
—
Data No.
91
PC Programming
¦ +BTM
Data
No.
0 1 / 9 1 : R N G T O N E = M
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~ C0)
Setting
Data