NEC Electra Elite IPK - CO;PBX Busy Forward Station Assignment

2 - 520 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-13 CO/PBX Busy Forward Station
Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call
terminates at a busy station.
Display
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK4 +
AC to access the Memory Block.
3 Use dial pad to change data.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109.
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
 Setting Data: Port No. 01 ~ 96
Default Values
Not specified
4 Press G to write the data and display Forward No. 2.
5 Enter second transfer Port No.
6 Press
G to write the data and display the next Memory Block.
7 Program the next Memory Block or press
E to go back on-line.
1. When the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a
second specified station (Forward 2).
2. When all three stations are busy, the first station rings.
3. Telephone ports A0~C0 are ports 100~120.
Telephone Mode
4
Submode
—
Data No.
13
PC Programming
¦ +BTT
0 1 / 1 3 : F W D 1 =
T I M E D I S P L A Y
Data
No.
Titl e
Tel
Port
No.
(01~C0)
Forward
No.
1/2
Setting
Data