NEC Electra Elite IPK - PC Programming Password Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 231
___________________________________________________________________________________
___________________________________________________________________________________
1-8-17 PC Programming Password
Assignment
General Description
Use this Memory Block to assign system passwords that must be entered when
connecting to the system using SAT PC Programming.
Display
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
AG to access the Memory Block.
3 Use the following to enter Class 1 (Technician Mode) and password (8 digits max.).
 Use the following to enter data:
K ~ I to enter numeric data
H to clear data
Default Values
Class 1, 2 All Blank
4 Press G to write the data and advance to Class 2 (End User Mode).
5 After entering Class 2 password, press
G to write the data. The next Memory Block is displayed.
6 Program next Memory Block or press
E to go back on-line.
1. Password 1 (Class 1) is used for Technician SAT PC Programming.
2. Password 2 (Class 2) is used for End User SAT PC Programming.
3. Password 1 (Class 1) can be assigned only by telephone programming. It cannot be assigned or changed by
Technician or End User SAT PC Programming.
4. Password 2 (Class 2) can be assigned by telephone programming or Technician SAT PC Programming. It
cannot be assigned or changed by End User SAT PC Programming.
5. Password 2 (Class 2) cannot be assigned until Password 1 (Class1) is assigned in the Memory Block.
6. The password for both classes can have up to five digits.
System Mode
1
Submode
8
Data No.
17
PC Programming
¦ +CSP
Data
No.
1 7 : ( 1 ) =
T I M E D I S P L A Y
Setting
Data
Class
No.
1,
2