NEC Electra Elite IPK - MOH or Ring Back Tone Selection

2 - 586 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-66 MOH or Ring Back Tone Selection
General Description
Use this Memory Block to assign MOH or Ring Back Tone for the outside party when a
trunk call is placed on hold by the Transfer key on a Multiline Terminal, hook flash from
a Single Line Telephone, or the Transfer or Hold key at a PSII station.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
MOH RBT
Programming Procedures
1 Go off-line.
2 Press LK4 +
FF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the setting data option.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and advance to the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
4
Submode
—
Data No.
66
PC Programming
¦ +BTT
0 1 / 6 6 : H O L D M O H
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No.
Title
Setting
Data