3 - 2 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
When Station Lockout is set at a station, the station is outgoing restricted.
Digit Restriction is not assigned.
Refer to Section 1.5 Code Restriction Tables (Default Values).
1.3 Memory Blocks
The following related Memory Blocks are used when assigning Code
Restriction.
Memory
Title Block
Trunk to Tenant Assignment...................................................2-01
Trunk-to-Trunk Group Assignment......................................... 3-03
Trunk Type Selection..............................................................3-91
PBX/CTX Access Code Assignment I.................................1-1-24
PBX/CTX Access Code Assignment II................................1-1-25
OCC Table Assignment.......................................................1-1-67
OCC Table to Trunk Group Assignment.................................5-03
8-Digit Matching Table to OCC Table Assignment.............. 1-1-68
8-Digit Matching Table to Normal Dial Assignment............. 1-1-66
8-Digit Matching Table to Trunk Group Assignment...............5-02
8-Digit Matching Table Assignment.....................................1-1-60
8-Digit Matching Table to Class Assignment.......................1-1-61
Code Restriction Class Allow/Deny Assignment.................1-1-65
System Speed Dial Restriction by Tenant........................... 1-1-18
System Speed Dial Override by Class Selection................ 1-1-62
Tie Line Code Restriction Assignment................................ 1-1-69
Code Restriction Class Assignment When Lockout is Set..1-1-70
CO Feature Codes Service for Code Restriction................ 1-1-82
Trunk Digit Restriction............................................................ 4-32
Code Restriction Class Assignment (Day Mode)................... 4-07
To Next Page
Loading...
