NEC Electra Elite IPK - 1-16-01 Port Speed Selection - 10;100 Base-T

Electra Elite IPK Document Revision 4
Programming Manual 2 - 381
___________________________________________________________________________________
___________________________________________________________________________________
1-16-01 Port Speed Selection – 10/100 Base-T
General Description
When Memory Block 1-16-00 (Auto Negotiation Yes/No Selection) is set to NO, use
this Memory Block to specify the Ethernet port speed as 10 Mbps or 100 Mbps for
each port of each HUB(8)-U( ) ETU.
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
10 100
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data.
5 Repeat steps 3 and 4 for each port.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
01
PC Programming
¦ +AB
0 1 : 1 - 1 S P E E D 1 0 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3