NEC Electra Elite IPK - Figure 3-4 VLAN Settings

Electra Elite IPK Document Revision 4
Programming Manual 3 - 59
___________________________________________________________________________________
___________________________________________________________________________________
VLAN Group 1 carries traffic marked VLAN ID = 100.
VLAN Group 2 carries traffic marked VLAN ID = 200.
H Port 1
In IP terminal programming, both the IP terminal and PC are configured for
VLAN tagging: IP terminal on VLAN 100, PC on VLAN 200. Traffic from
both VLAN 100 and VLAN 200 must be permitted to go through port 1.
VLAN tags should be inserted for each.
H Port 2
Not Used
H Port 3
PC is a member of VLAN 200 but does not support VLAN tag insertion. The
PC does not respond to VLAN-tagged traffic.
H Port 4
MG(8) ETU, Elite VoIP ETU that does not support VLAN tags on VLAN 100.
H Port 5
IP terminal with VLAN tagging support on VLAN 100.
H Port 6
IPC ETU, ELite VoIP ETU that does not support VLAN tags on VLAN 100.
H Port 7
IP terminal with VLAN tagging support on VLAN 100.
Figure 3-4 VLAN Settings
Depicts Memory Blocks
Settings:
1-16-13 VLAN Group to
VLAN ID Assignment
1-16-14 Port VLAN
Group Membership
1-16-15 VLAN Tag
Insertion Selection