NEC Electra Elite IPK - APR;APA Hookflash Selection

2 - 578 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-59 APR/APA Hookflash Selection
General Description
Use this Memory Block to allow/deny Hookflash for Analog Port Adapter with Ringer
(AP(R)-R/APR-U) or Analog Port Adapter (AP(A)-R/APA-U) without ringer on a
Multiline Terminal.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK4 +
EI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the setting data option.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display Memory Block 4-1 for next Tel Port No.
5 Program the next Tel Port No. or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-02
Hookflash Time Selection
1-3-02
SLT Hookflash Signal Selection
4-39
APR Ring Mode Assignment
CO/PBX Line Mod
e
4
Submode
—
Data No.
59
PC Programming
¦ +AU
0 1 / 5 9 : H K F L S H N O
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No.
Title
Setting
Data