NEC Electra Elite IPK - Tie Line Answer Detect Time Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 441
___________________________________________________________________________________
___________________________________________________________________________________
3-17 Tie Line Answer Detect Time
Selection
General Description
Use this Memory Block to specify the time before an Electra Elite IPK system answer
(off-hook) is recognized as an answer.
Display
Settings
Page 1
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default. Times
are in
milliseconds.
0 130 260 390 520 650 780 910
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
1040 1170 1300 1430 1560 1690 1820 1950
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + AG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change answer detect time for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. Answering a call may be impossible if the CO answer detect time is too long.
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
CO/PBX Line Mod
e
3
Submode
—
Data No.
17
PC Programming
¦ +ALM
0 1 / 1 7 : A N S 5 2 0 | 1
T I M E D I S P L A Y
CO/PBX
(01~64)
Data
No.
Title
Setting
Data
Page