NEC Electra Elite IPK - Centralized BLF Receive Extension Number Assignment

2 - 370 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-18 Centralized BLF Receive Extension
Number Assignment
General Description
Use this Memory Block to assign the Extension Numbers of remote systems to receive
Centralized BLF messages.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
AH to access the Memory Block.
3 Use dial pad keys to enter Table No. and Extension No.
 Use the following to enter data:
J to move cursor left
L to move cursor right
K ~ I to enter numeric data
 Setting data includes:
Three Digit Extension Numbers: 100~899
Four Digit Extension Numbers: 1000~8999
Tables: 001~120
Default Values
:
All Tables Not Specified
4 Press G to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each Table No.
6 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-8-08
Class of Service (Station) Feature Selection 2 (Page 6, LK 2)
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
System Mode
1
Submode
15
Data No.
18
PC Programming
¦ +AW
1 8 : B L F 0 0 1 =
T I M E D I S P L A Y
Data
No.
Table
Number
001~120
Title
Extension
Number