NEC Electra Elite IPK - DSS Call Voice;Tone Signal Selection

2 - 184 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-6-03 DSS Call Voice/Tone Signal Selection
General Description
Use this Memory Block to specify whether Voice or Tone signaling is to be used first
when calling an extension from an Attendant Add-On Console.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
TONE VOICE
Programming Procedures
1 Go off-line.
2 Press LK1 + LK6
+ J + J + C .
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-01
Attendant Add-On Console to Telephone Port Assignment
1. To switch Voice/Tone signaling, dial 1 from a station.
2. When tone signaling is programmed in this Memory Block, the called party cannot answer handsfree unless the
Direct Station Select (DSS) station user dials 1 to switch it to Voice.
System Mode
1
Submode
6
Data No.
03
PC Programming
¦ +BTD
0 3 : V O I C E C A L L
T I M E D I S P L A Y
Setting
Data
Data
No.