NEC Electra Elite IPK - Trunk Status Selection

2 - 426 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-02 Trunk Status Selection
Use this Memory Block to specify whether a CO/PBX line is used for call origination
and termination or termination only.
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK8 The shaded
selection is the
default.
OUT&IN IN
Programming Procedures
1 Go off-line.
2 Press LK3 +
G to access the Memory Block.
3 Press the corresponding CO/PBX Line Key to change the option.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
02
PC Programming
¦ +BCT
0 1 / 0 2 : O U T & I N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting Data
Data
No.
Setting Data