NEC Electra Elite IPK - CO Line Mode Copy Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 621
___________________________________________________________________________________
___________________________________________________________________________________
6-3 CO Line Mode Copy Assignment
Use this Memory Block to enable copying data from one CO/PBX line to another CO/
PBX line or multiple consecutive CO/PBX lines.
Display
Example: To copy data of CO/PBX line 01 to CO/PBX line 05~07:
1. Enter the original CO/PBX No. Using the dial pad, press
KA .
2. Press
G .
Programming Procedures
1 Go off-line.
2 Press LK6 + LK3 to access the Memory Block.
3 Enter the CO/PBX line to be copied.
 Use the following to enter data:
K ~ I to enter numeric data
H to clear all data when placed at cursor position
Copy Mode
6
CO/PBX
3
Data No.
—
Copy Mode
6
Tenant
3
Data No.
—
C O – – >
T I M E D I S P L A Y
Title
Setting
Data
Original
CO/PBX No.
(01~64)
C O 0 1 – – >
T I M E D I S P L A Y
– – > C O –
T I M E D I S P L A Y