NEC Electra Elite IPK - System Data List

Electra Elite IPK Document Revision 4
Programming Manual 1 - 13
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 3 SYSTEM DATA LIST
The System Data List is a complete list of Memory Blocks that are available in the
Electra Elite IPK system. The information is organized by mode, submode, and then
numerically by Memory Block number. The Memory Block number and name, the
default values, and programming values are provided for each Memory Block.
LK 1 System Mode
LK 1 CO Line
Data
No.
Memory Block Name Default Value Programming Values
00 Pause Time Selection 3.0s 1.0s, 3.0s
01 DP Interdigit Time Selection B Pattern A or B
02 Hookflash Time Selection 600ms 20ms, 40ms, 60ms, 80ms, 100ms,
140ms,
160ms, 200ms, 400ms, 600ms,
800ms,
1.0s, 1.5s, 2.0s, 3.0s, 5.0s
03 Hold Recall Time Selection
(Non-Exclusive Hold)
25s (R2500 or lower)
60s (R3000 or
higher)
25s, 45s, 60s, 90s, 120s, 180s, 240s,
∞ (No Limit)(R2500 or lower)
000s (No Limit), 001s~255s (R3000 or
higher)
04 Automatic Redial Time Selection Table 1: 030
Table 2: 060
Table 3: 002
Table 1: 001 ~ 050 sec.
Table 2: 001 ~ 100 sec.
Table 3: 001 ~ 015 times
05 Start Time Selection 10s (R2500 or lower)
02s (R3000 or
higher)
2s, 10s, 20s, 30s, 40s, 50s, 60s, 70s
(R2500 or lower)
00s (No Limit), 01s~99s (R3000 or
higher)
06 CO/PBX Incoming Ringing Alarm
Time Selection
∞ (No Limit) (R2500
or lower)
000s (R3000 or
higher)
10s, 20s, 30s, ∞ (R2500 or lower)
000s (No Limit), 001s~255s (R3000 or
higher)
07 Tie Line Delay Ringing Time
Selection
∞ (No Limit) (R2500
or lower)
000s (R3000 or
higher)
10s, 20s, 30s, ∞ (R2500 or lower)
000s (No Limit), 001s~255s (R3000 or
higher)
09 Manual Pause Selection NO NO, YS
11 System Transfer/Camp-On
Selection
YS NO, YS