NEC Electra Elite IPK - Internal Paging Timeout Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 105
___________________________________________________________________________________
___________________________________________________________________________________
1-2-00 Internal Paging Timeout Selection
General Description
Use this Memory Block to specify the time allowed for paging.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (R2500 or lower)
Settings
Refer to next page for R3000 or higher Programming Procedures.
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
90s 120s
∞
(No Limit)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
2
Data No.
00
PC Programming
¦ +BP
0 0 : P A G I N G 9 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
Setting
Data