NEC Electra Elite IPK - 3-Minute Alarm Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 605
___________________________________________________________________________________
___________________________________________________________________________________
4-94 3-Minute Alarm Selection
General Description
Use this Memory Block to specify per station whether or not a warning tone is
generated at 3-minute intervals during an outgoing or incoming CO/PBX call.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK4 +
ID to access the Memory Block.
3 Press LK2 to generate a three-minute warning tone during a call for Tel port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. A 1-second (approximately) warning signal sounds every three minutes during CO/PBX calls.
2. The alarm tone is heard through the terminal speaker only.
3. When the built-in speakerphone is used for handsfree, the warning signal is not used.
4. Telephone ports A0~C0 are ports 100~120.
Telephone Mode
4
Submode
—
Data No.
94
PC Programming
¦ +BTM
Data
No.
0 1 / 9 4 : 3 m A L M N O
T I M E D I S P L A Y
Tel
Port
No.
(01
~ C0)
Title
Setting
Data