NEC Electra Elite IPK - 1-11-05 T1 Channel Selection

2 - 294 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-11-05 T1 Channel Selection
General Description
Use this Memory Block to specify the digital trunk interface (DTI) channel numbers to
be used.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK11 + KE to access the Memory Block.
3 Press the corresponding CO/PBX line key to select DTI channel number.
 Use to following to enter data:
C to go to the next page
Default Values
DTI No. 1 Channels 01~24 = Off
DTI No. 2 Channels 01~24 = Off
DTI No. 3 Channels 01~24 = Off
DTI No. 4 Channels 01~24 = Off
DTI No. 5 Channels 01~24 = Off
DTI No. 6 Channels 01~24 = Off
DTI No. 7 Channels 01~24 = Off
DTI No. 8 Channels 01~24 = Off
4 Press G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
11
Data No.
05
PC Programming
¦ +AD
0 1 / 0 5 : C H A N E L | 0 1
T I M E D I S P L A Y
Data
No.
Channel
No.
DTI No.
(01~08)
Title
Channel Numbers (01~24) correspond to CO/PBX line key.
CO/PBX
Line
Key
Channel No.
Page
DTI No.
1
DTI No.
2
DTI No.
3~8
01~08 01~08 01~08 01~08 1
09~16 09~16 09~16 09~16 2
17~24 17~24 17~24 17~24 3
CO/PBX
Line LED
Off On
Data
No
(Not Assigned)
Yes
(Assigned)
The shaded
selection is the
default.