NEC Electra Elite IPK - Station to Timer Class of Service

2 - 596 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-71 Station to Timer Class of Service
General Description
Use this Memory Block to specify the Timer Class of Service per station.
R3000 or higher is required.
Programming Procedures
1 Go off-line.
2 Press LK4 +
GA to access the Memory Block.
3 Use the dial pad to change Station to Timer Class of Service.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter Restriction Class or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
Default Value
Tel Ports 1 & 2 = Class 1
All other ports = Class 2
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
E to go back on-line.
CO/PBX Line Mod
e
4
Submode
—
Data No.
71
PC Programming
¦ +AC
0 1 / 7 1 : T M R C L S 1
T I M E D I S P L A Y
Tel Po rt
No.
(01~CO)
Data
No.
Title
Setting
Data
1~4