NEC Electra Elite IPK - Tenant Mode Copy Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 619
___________________________________________________________________________________
___________________________________________________________________________________
6-2 Tenant Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one tenant to another tenant or
multiple consecutive tenants.
Display
Example: To copy data of Tenant 00 to Tenant 05~07:
1. Enter the original Tenant No. Using the dial pad, press
KK .
2. Press
G .
Programming Procedures
1 Go off-line.
2 Press LK6 +
LK2 to access the Memory Block.
3 Enter the tenant to be copied.
 Use the following to enter data:
K ~ I to enter numeric data
H to clear all data when placed at cursor position
Copy Mode
6
Tenant
2
Data No.
—
T N A T – – >
T I M E D I S P L A Y
Title
Setting
Data
T N A T 0 0 – – >
T I M E D I S P L A Y
– – > T N A T –
T I M E D I S P L A Y