NEC Electra Elite IPK - 1-15-04 Destination Point Code Assignment; Destination Point Code Transfer Assignment; Originating Office Code Number Assignment; K-CCIS Message Response Timeout Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 341
___________________________________________________________________________________
___________________________________________________________________________________
1-15-04 Destination Point Code Assignment
General Description
Use this Memory Block to assign the Destination Point Code for each Common
Signaling Channel.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
KD to access the Memory Block.
3 Use dial pad keys to enter Setting Data.
 Use the following to enter data:
J to move cursor left
L to move cursor right
K ~ I to enter numeric data
 Point Code Range is 00001~16367.
Default Values
:
Blank
4 Press G to write the data.
5 Press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Timeout Assignment
System Mode
1
Submode
15
Data No.
04
PC Programming
¦ +AW
0 4 : D S T C C H 1
T I M E D I S P L A Y
Title
Setting
Data
Data
No.
C-Channel
1~4