NEC Electra Elite IPK - SLT;ISDN TELCO Account Codes Allow;Deny Selection

2 - 150 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-3-12 SLT/ISDN TELCO Account Codes
Allow/Deny Selection
General Description
Use this Memory Block to specify when ISDN (PRI/BRI) circuits have account codes
set up by TELCO that must be entered by Single Line Telephone users.
R3000 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded selection is the
default.
NO YES
Programming Procedures
1 Go off-line.
2 Press LK1 + LK3 +
AB to access the Memory Block.
3 Press the corresponding CO/PBX key to change data option.
4 Press
G to write the data and advance to the next Memory Block.
5 Press
E to go back on-line.
System Mode
1
Submode
3
Data No.
12
PC Programming
¦ +BTI
1 2 : I S D N A . C . N 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data