NEC Electra Elite IPK - APR Ring Mode Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 549
___________________________________________________________________________________
___________________________________________________________________________________
4-39 APR Ring Mode Assignment
General Description
Use this Memory Block to specify the ringing mode for a Single Line Telephone
connected to an AP(R)-R or APR-U Unit.
Display
Settings
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
NON
(No Ring)
STA
(Station
Number)
ALL
Programming Procedures
1 Go off-line.
2 Press LK4 +
CI to access the Memory Block.
3 Press line key to specify ringing Mode for a single line telephone connected to an APR-U Unit for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
39
PC Programming
¦ +BTM
0 1 / 3 9 : A P R S T A
T I M E D I S P L A Y
Data
No.
Tel
Port
No.
(01
~ C0)
Title
Setting
Data