NEC Electra Elite IPK - Enhanced 911 CESID to Station Table Assignment

2 - 570 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-54 Enhanced 911 CESID to Station Table
Assignment
General Description
Use this Memory Block to specify E911 Caller Emergency Service Identification
(CESID).
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
ED to access the Memory Block.
3 Enter data using dial pad. Enter 7- or 10-digit code plus up to 5-digit extension number (15 digits maximum) for Tel port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
H to clear data when cursor is at setting data position
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
54
PC Programming
¦ +AE
0 1 / 5 4
T I M E D I S P L A Y
Data
No.
Tel
Port
No.
(01
~ C0)
Setting
Data