NEC Electra Elite IPK - CO;PBX Ringing Pattern Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 489
___________________________________________________________________________________
___________________________________________________________________________________
3-67 CO/PBX Ringing Pattern Selection
General Description
Use this Memory Block to specify the ringing pattern assigned to each CO/PBX line.
Display
Settings
Page 1
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
– (None)
Ringing
Pattern A
Ringing
Pattern B
Ringing
Pattern C
Ringing
Pattern D
Ringing
Pattern E
Ringing
Pattern F
Ringing
Pattern G
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
Ringing
Pattern H
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + FG to access the Memory Block.
3 Press line key to specify the Ringing pattern assigned to CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the selected data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
4-57
CO Line Ringing Pattern Priority Selection
CO/PBX Line Mod
e
3
Submode
—
Data No.
67
PC Programming
¦ +BCT
0 1 / 6 7 : C O R N G – | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page