NEC Electra Elite IPK - 1-15-00 K-CCIS Main;Remote Office Selection; Common Signal Channel Data Speed Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 333
___________________________________________________________________________________
___________________________________________________________________________________
1-15-00 K-CCIS Main/Remote Office Selection
General Description
Use this Memory Block to activate K-CCIS by assigning a Main or Remote system.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NONE MAIN REMOTE
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data.
5 Press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Timeout Assignment
1-15-08
Link Reconnect Allow/Deny Selection
1-15-09
K-CCIS Maximum Call Forwarding Hop Assignment
System Mode
1
Submode
15
Data No.
00
PC Programming
¦ +AW
0 0 : C C I S N O N E
T I M E D I S P L A Y
Data
No.
Setting
Data
Title