NEC Electra Elite IPK - Page 411

2 - 334 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
 Notes 
1-15-10
Calling Name Display Allow/Deny Selection
1-15-11
Centralized Billing Allow/Deny Selection
1-15-12
Centralized Billing – Point Code of Center Office Assignment
1-15-13
Centralized Day/Night Switching for Remote Office Assignment
1-15-14
Centralized Day/Night Switching for Main Office Assignment
1-15-15
Centralized BLF Send Point Code Assignment
1-15-16
Centralized BLF Send Extension Number Assignment
1-15-17
Centralized BLF Send Time Assignment
1-15-18
Centralized BLF Display Extension Number Assignment
3-70
CIC Number Assignment
5-05
Common Signaling Channel Route Selection
1-1-05
Start Time Selection
1-5-02
SMDR Print Format
1-5-13
Printer Connected Selection
1-5-14
Printer Line Feed Control Selection
1-5-25
SMDR Valid Call Time Assignment
1-5-26
SMDR Incoming/Outgoing Print Selection
1-8-35
COM Port Baud Rate Setting Assignment
4-56
SMDR Telephone Print Selection
1. For Electra Elite IPK-to-Electra Elite IPK Network only one system can be set for Main. All other systems must
be set from Remote.
2. When connected to a PBX, the Electra Elite IPK must be set for REMOTE in this Memory Block.
3. When this Memory Block is set to NONE,
K-CCIS with point-to-point T1 lines does not function even when all
other
K-CCIS Memory Blocks are allowed.
4. The Main or Remote setting only applies to the Centralized Day/Night Mode Change - K-CCIS feature and only
when using traditional K-CCIS with point-to-point T1 lines and IP(K-CCIS) to NEAX ( Point-to-Multipoint) (R2500
or higher).
5. This Memory Block is not used and has no effect on the IP (K-CCIS) feature (R1700 or lower).
Related Programming (Continued)
M.B. Number Memory Block Name