NEC Electra Elite IPK - Line Key Selection (Memory Block 3-53); CO;PBX Ring Assignment (Day Mode) (Memory Block 4-01); CO;PBX Ring Assignment (Night Mode) (Memory Block 4-02); Line Key Selection for Telephone Mode (Memory Block 4-12)

3 - 36 Advanced Applications
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
3.3.21 Line Key Selection (Memory Block 3-53)
Use this Memory Block to check the speed dialing buffer for a match
when a Caller ID Number is detected. When a name is assigned to a
matched number, it can be displayed when Line key 3 (NAM) is
selected.
Default: NUM
3.3.22 Trunk Type Selection (Memory Block 3-91)
Use this Memory Block to specify an external line as CO, PBX (or
CTX), TIE, DID, or CTX (Assume 9).
Default: CO
3.3.23 Trunk (Installed, DP/DTMF) Selection (Memory Block 3-92)
Use this Memory Block to specify an external line as NIL (Not
connected), DP 10 pps, DP 20 pps, or MF (DTMF).
Default: MF
3.3.24 CO/PBX Ring Assignment (Day Mode) (Memory Block 4-01)
Use this Memory Block to assign incoming CO/PBX calls to ring on
Multiline Terminals in the Day mode.
Default: Lines 01~08 ring at telephone ports 01 and 02
3.3.25 CO/PBX Ring Assignment (Night Mode) (Memory Block 4-02)
Use this Memory Block to assign incoming CO/PBX calls to ring on
Multiline Terminals in the Night mode.
Default: Lines 01~08 ring at telephone ports 01 and 02
3.3.26 Telephone to Tenant Assignment (Memory Block 4-09)
Use this Memory Block to specify Tenant assignment per station.
Default: All telephones assigned to Tenant 00
3.3.27 Line Key Selection for Telephone Mode (Memory Block 4-12)
Use this Memory Block to assign functions to each CO/PBX line key
on each tenant assigned to telephone mode.
Default: Line keys 01~08 are assigned as CO/PBX lines 01~08 for all
telephones.