NEC Electra Elite IPK - Hold Internal Tone Volume Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 241
___________________________________________________________________________________
___________________________________________________________________________________
1-8-32 Hold Internal Tone Volume Selection
General Description
When the internal Music On Hold source is used, this Memory Block can be used to
pad the music by -6 dB.
Display
Settings
LK 1 LK 2 The shaded
selection is the
default.
0dB -6dB
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
CB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the dB setting
.
Default ValuesDefault Values
0 dB
4 Press G to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-31
Hold Tone Source Assignment
System Mode
1
Submode
8
Data No.
32
PC Programming
¦ +BCS
3 2 : H L D T V O L 0 d B
T I M E D I S P L A Y
Data
No.
Setting
Data
Title