NEC Electra Elite IPK - DIT;ANA Delay Answer Time Selection

2 - 482 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-61 DIT/ANA Delay Answer Time
Selection
General Description
Use this Memory Block to specify the time an incoming call rings before being
changed to a DIT/ANA call.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (2500 or lower)
Settings
Related Programming
Refer to next page for R3000 or higher Programming Procedures.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
0s 5s 10s 20s 30s 40s 50s 60s
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + FA to access the Memory Block.
3 Press the applicable line key to change the time an incoming call rings before it is changed to a DIT/ANA call on CO/PBX NO.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the selected data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
61
PC Programming
¦ +BCT
0 1 / 6 1 : D L Y A N S 0 s
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Title