NEC Electra Elite IPK - 1-16-04 VLAN Mode Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 387
___________________________________________________________________________________
___________________________________________________________________________________
1-16-04 VLAN Mode Selection
General Description
Use this Memory Block to specify whether or not IEEE 802.1q VLAN Tagging is
enabled for each HUB(8)-U( ) ETU. This Memory Block must also be enabled to use
IEEE 802.p Priority. Priority options can be enabled in Memory Block 1-16-06 (Port
Based Priority Selection), Memory Block 1-16-07(High Priority RX Tag Threshold),
Memory Block 1-16-08 (High Priority TX Tag Assignment), and Memory Block 1-16-09
(Low Priority TX Tag Assignment).
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
04
PC Programming
¦ +AB
0 4 : 1 V L A N N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
HUB
1~3