NEC Electra Elite IPK - Tie Line Reorder Tone Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 457
___________________________________________________________________________________
___________________________________________________________________________________
3-28 Tie Line Reorder Tone Selection
General Description
Use this Memory Block to specify whether or not to send a reorder tone to the
originating station when the number of a distant system is used to originate a call over
a Tie line.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + BH to access the Memory Block.
3 Press LK1 to cancel a reorder tone to the originating system for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
28
PC Programming
¦ +ALT
0 1 / 2 8 : R O T Y S
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
CO/PBX
No.
(01~64)
Electra
Elite IPK
Reorder
Tone
Sending
8 - 12
Distant
System

1111

Originating Side
12