NEC Electra Elite IPK - DIT Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 471
___________________________________________________________________________________
___________________________________________________________________________________
3-42 DIT Assignment
General Description
Use this Memory Block to assign a Day Mode direct trunk termination to an
independent station.
R2500 is required for 5-, 6-, or 7-digit Extension Numbers.
Display (R1700 or lower)
Display
(R2000 or higher)
 The number displayed after DIT (XXX) is from Memory Block 1-2-34 (Expanded Station Number Assignment) when assigned
(R2500 is required).
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + DB to access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to assign DIT to a station.
 Use the following to enter data:
J to moves the cursor left
L to moves the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX Line No.
 Enter the following:
Station No. (2-, 3-, or 4-digits 10~8999)
CO Port No. (01~64)
Default Values
No Assignment
4 Press G to write the data and display the next Memory Block.
CO/PBX Line Mod
e
3
Submode
—
Data No.
42
PC Programming
¦ +BCT
0 1 / 4 2 : D I T D —
T I M E D I S P L A Y
Data
No.
Setting Data
(Incoming)
CO/PBX
No.
(01~64)
Title
0 1 / 4 2 : D I T X X X
T I M E D I S P L A Y
Data
No.
Setting Data
(Incoming)
CO/PBX
No.
(01~64)
Title